Room Addition Cost in Sherman Oaks (2026): Prices, Sizes and Timeline
What a room addition costs in Sherman Oaks, how long it takes, and what moves the number on the flats north of Ventura Boulevard and on the hillside lots south of it.
A room addition in Sherman Oaks costs about $70K–$140K for a bump-out, $140K–$280K for a full room or primary suite and $280K–$500K+ for a second story in 2026. Plan on 2–4 months of design, engineering and LADBS plan check, then 3–6 months of construction; hillside lots south of Ventura Boulevard sit at the upper end of each range. The ranges come from the Sherman Oaks projects we price and move with square footage, the foundation, how far plumbing and electrical have to travel, hillside conditions and finishes. Your own number is a fixed, written price after a free on-site visit.
Right Image Builders (CSLB #1021284) is a licensed room addition contractor in Sherman Oaks, based in Valley Glen about 10 minutes away; we design, engineer, permit and build additions under one contract.
Sherman Oaks room addition prices at a glance
| Addition type | 2026 planning range | What it usually is | Typical schedule |
|---|---|---|---|
| Bump-out | $70K–$140K | A few hundred square feet: a bigger kitchen or dining area, a mudroom, a small bedroom | Toward the short end of 3–6 months of construction |
| Room or primary suite | $140K–$280K | A full room or a bedroom, walk-in closet and bath, on its own foundation | 2–4 months of design and plan check, then 3–6 months of construction |
| Second story | $280K–$500K+ | A full or partial upper floor with stairs, structural reinforcement below and a new roof | 3–5 months of design and plan check, then 4–6 months of construction |
These are planning ranges, not quotes. They cover design, structural engineering, permits, construction and standard finishes; they do not cover furniture, landscaping beyond the work area, or a service upgrade the utility charges separately.
What does a 12×12, 20×20 or 500 sq ft addition cost?
Size decides which tier a project falls in more than anything else. A 12×12 bedroom (144 sq ft) or a 12×24 family-room extension (288 sq ft) is bump-out territory, $70K–$140K, depending mostly on whether it carries plumbing. A 20×20 family room (400 sq ft) or a 350–600 sq ft primary suite with its own bath is a room or suite addition, $140K–$280K. Above roughly 500 sq ft the school fee applies as well (see below).
Price per square foot is a poor yardstick on small additions. The fixed costs (design, engineering, the permit, the foundation edge, the roof tie-in and matching the stucco) are spread over fewer feet, so a 150 sq ft bump-out costs more per foot than a 450 sq ft suite. Ask for a price for the whole scope, not a rate.
Why Sherman Oaks costs what it does
Sherman Oaks is two different building sites. North of Ventura Boulevard, in Chandler Estates, Sherman Village and the flats around them, the typical house is a 1,600–2,200 sq ft 1940s–60s ranch on a 7,000–9,000 sq ft R1 lot, mostly on a slab. A rear or side addition there is a straightforward foundation-and-framing job, and the price is driven by what goes inside it. South of Ventura, toward Longridge Estates and Mulholland, the lots slope, many parcels are zoned RE, and the Baseline Hillside Ordinance applies to designated Hillside Area lots. Grading, retaining walls, a soils report, deeper footings and harder access push the same addition up the range.
- The foundation. A slab addition ties into the existing slab; a raised foundation with a crawlspace needs matching footings and framing, and hillside lots may need caissons or stepped footings.
- Plumbing. A bathroom in the addition is the biggest single swing; on a slab, every new drain is trenched. Galvanized supply lines in older ranches are often replaced at the same time.
- Electrical. Many 1950s Sherman Oaks ranches still have 100-amp panels; an addition with a bath, HVAC and lighting often triggers a 200-amp LADWP service upgrade.
- Matching the house. Stucco texture, roof pitch and material, window proportions and the floor height are matched so the addition reads as original. A clay-tile roof or a mid-century post-and-beam house costs more to match than a composition-shingle ranch.
- Finishes. Flooring, tile, cabinetry and fixtures move the number inside every tier.
Fees and costs beyond construction
LADBS plan check and permit fees are set from the project valuation and are paid at submittal and at issuance; we include them in the fixed price. School fees apply to residential additions over 500 sq ft of assessable space under Education Code §17620; LAUSD exempts additions of 500 sq ft or less. Title 24 energy compliance documents are part of every permit set. On hillside lots, a soils or geology report is usually required before plan check. Finally, property tax: the Los Angeles County Assessor values the new square footage as new construction and adds it to your existing Proposition 13 base; the rest of the house keeps its assessed value.
How long a Sherman Oaks room addition takes
Design, engineering and LADBS plan check at the Van Nuys Development Services Center usually take 2–4 months for a ground-floor addition and 3–5 months for a second story, longer on a hillside lot that needs a soils report. Construction then runs 3–6 months for a ground-floor room or suite and 4–6 months for a second story. Most families stay in the house during a ground-floor addition; a second story usually means planning for the weeks when the roof is open. The Sherman Oaks permit guide walks through plan check step by step.
Build out, build up, or build something else?
Building out is cheaper per square foot because there are no stairs and no reinforcement of the existing house. Building up wins on a small lot, when the yard matters, or when the ground floor is already near the floor-area limit; the second story guide for Sherman Oaks covers when a house can carry one. If the space should be independent, with its own kitchen and entrance that you could rent, an ADU may be the better project; the room addition vs. ADU guide compares the two.
Three typical Sherman Oaks scopes and where they land
These are illustrative scopes, not quotes, to show how the tiers work in practice.
- A 12×16 bedroom off the back of a flat-lot ranch, no plumbing. Slab foundation tied to the existing slab, framing, a roof that continues the existing pitch, two windows, electrical and a mini-split. It sits in the bump-out tier, $70K–$140K, toward the middle once the stucco and roof match are priced.
- A 450 sq ft primary suite with a walk-in closet and a full bath. A new foundation, plumbing trenched to the existing lines, a 200-amp service upgrade, tile, glass and cabinetry. It sits in the room-or-suite tier, $140K–$280K, and crosses the 500 sq ft school-fee line only if the suite grows.
- A 700 sq ft second floor with two bedrooms and a bath over a 1950s ranch. Structural evaluation, new footings and shear walls below, stairs, a new roof and matched exterior. It sits in the second-story tier, $280K–$500K+, and at the top of it on a hillside lot south of Ventura.
In each case the biggest variables are the same: the foundation, the plumbing, the electrical service and how hard the existing house is to match. A walkthrough settles all four in about an hour.
How we price a Sherman Oaks addition
One fixed, written price after a free on-site visit: we pull the parcel on ZIMAS, measure the house, check the panel, the plumbing and the foundation, and itemize the whole scope, including the design, engineering, permits and inspections. Anything the walls hide is priced in writing before the crew continues, and the final payment comes after your walkthrough. The deposit on a home-improvement contract in California is capped at $1,000 or 10 percent of the price, whichever is less. To start, see our room addition contractor page for Sherman Oaks.
Sources (checked November 2026): Los Angeles Department of Building and Safety, plan check and permit information; ZIMAS parcel lookup (zone, floor-area limit, hillside and overlay flags for any City of Los Angeles address); Los Angeles City Planning, zoning (ZIMAS), ADU ordinance and the Baseline Mansionization and Hillside ordinances; Los Angeles County Assessor: new construction is assessed and added to the existing Proposition 13 base; Education Code §17620 and the LAUSD Impact Fee Office: school fees on residential construction; additions of 500 sq ft or less of assessable space are exempt; Business and Professions Code §7044 (owner-builder permits) and §7159 (home-improvement contracts: down payment capped at $1,000 or 10 percent, whichever is less); Right Image Builders service and neighborhood pages (2026 planning ranges, timelines, permit authorities). Cost figures are Right Image Builders' 2026 planning ranges from its service and neighborhood pages.
Read before you hire anyone.
Plain answers on costs, permits, materials and hiring, written for Los Angeles houses and kept current.
How Much Does a Whole-Home Remodel Cost in Los Angeles in 2026?
Whole-home remodel cost in Los Angeles, 2026: per-sq-ft planning ranges with and without structural work, by…
Read the guide →Decision guideWhole-Home Remodel or Tear-Down Rebuild: How to Decide in Los Angeles
Remodel the whole house or tear it down? When the structure is worth keeping, LA floor-area and hillside rules, tax…
Read the guide →Decision guideRemodel or Move? How to Decide in Los Angeles
Remodel or move in Los Angeles (2026)? Prop 13 and 19, transfer taxes and Measure ULA, what an addition or remodel…
Read the guide →AnswersHow to hire a contractor
Direct answers from the Los Angeles remodeling FAQ, kept current.
Read the answers →Frequently Asked
Questions
About $70K–$140K for a bump-out, $140K–$280K for a full room or primary suite, and $280K–$500K+ for a second story. Where a project lands depends on its size, whether it includes a bathroom, the foundation type and whether the lot is on the flats or the hillside south of Ventura Boulevard.
A 20×20 addition is 400 sq ft, which puts it in the room-or-suite tier, $140K–$280K in Sherman Oaks. A family room without plumbing sits toward the lower half; a bedroom suite with a full bath, or a hillside lot with grading and deeper footings, toward the top.
No, usually the opposite. Design, engineering, permits, the roof tie-in and matching the exterior cost about the same whether the addition is 150 or 450 square feet, so small bump-outs carry a higher price per foot even though the total is lower.
Yes, but only for the new part. The Los Angeles County Assessor values the added square footage as new construction and adds that value to your existing Proposition 13 base; the original house keeps its assessed value.
Only if the addition adds more than 500 sq ft of assessable space. LAUSD charges school fees on larger residential additions under Education Code §17620 and exempts additions of 500 sq ft or less; the fee is paid before the building permit is issued.
Budget two to four months for drawings, engineering and the LADBS review, then three to six months of building for a ground-floor room or suite. A second story takes longer on both sides of the permit, and a hillside lot adds a soils report before plan check.
Room Addition Contractor in Sherman Oaks
Design, permits and construction, one contract →
GuideSecond Story Additions in Sherman Oaks
Can your house go up? →
GuideRoom Addition Permits in Sherman Oaks
What your lot allows and how LADBS reviews it →
Service HubRoom Addition Contractor in Los Angeles
Every addition type we build →
GuideBuild Up or Build Out?
Second story vs. ground-floor addition →
GuideRoom Addition vs. ADU
Connected space or a second dwelling →
Get a Fixed Price for
Your Sherman Oaks Addition
Free on-site estimate anywhere in Sherman Oaks: we pull your parcel on ZIMAS, look at the structure and the yard, and give you a written recommendation and a fixed price before any design work.
(818) 210-4544