Room Addition Cost in Studio City (2026): Flats, Canyons and What Moves the Price
What a room addition costs in Studio City, how the flats north of Ventura Boulevard differ from Fryman and Laurel Canyon, and how long it takes.
A room addition in Studio City costs about $75K–$145K for a bump-out, $145K–$290K for a room or primary suite and $290K–$520K+ for a second story in 2026. Design, engineering and LADBS plan check take 2–4 months, construction 3–6 months; canyon lots in Fryman and Laurel Canyon cost more than the flats north of Ventura Boulevard. The ranges are the Studio City planning ranges we publish, and they move with size, foundation, how far the plumbing and electrical have to travel, hillside work and finishes.
Right Image Builders (CSLB #1021284) is a licensed room addition contractor in Studio City, based in Valley Glen 10–15 minutes away.
Studio City room addition prices at a glance
| Addition type | 2026 planning range | Typical Studio City scope | Schedule |
|---|---|---|---|
| Bump-out | $75K–$145K | A family room or dining extension off the back of a flat-lot mid-century, a few hundred square feet | Short end of 3–6 months of construction |
| Room or primary suite | $145K–$290K | A bedroom, closet and bath on its own foundation, matched to the existing roofline | 2–4 months of design and plan check, then 3–6 months |
| Second story | $290K–$520K+ | A full or partial upper floor over a 1,500–2,000 sq ft mid-century, with the first floor reinforced | 3–5 months of design and plan check, then 4–6 months |
Planning ranges, not quotes. They include design, structural engineering, permits, construction and standard finishes, but not furniture, landscaping outside the work area or a utility charge for a new service.
Two Studio Citys: the flats and the canyons
North of Ventura Boulevard, in Colfax Meadows, Woodbridge Park and the blocks around Radford Studio Center, the typical house is a 1,500–2,000 sq ft mid-century on a flat 6,000–7,500 sq ft R1 lot, much of it on a slab. A rear addition there is a predictable foundation-and-framing job, and the price follows what goes inside it: a bath, a closet, the finish level.
South of Ventura, in the Silver Triangle, Fryman Canyon and Laurel Canyon, the lots slope, many are zoned RE and the Baseline Hillside Ordinance applies to designated Hillside Area parcels. The same 400 sq ft room there may need a soils report, retaining walls, caissons or stepped footings and a crane day for materials, and narrow canyon streets add staging time. That is why the canyon jobs sit at the top of each range.
What a 12×12, 20×20 or 500 sq ft room costs in Studio City
A 12×12 bedroom (144 sq ft) or a 12×24 den is bump-out work, $75K–$145K on the flats, more on a slope. A 20×20 family room (400 sq ft) or a 350–600 sq ft primary suite with its own bath falls in the $145K–$290K tier. Past 500 sq ft the school-district fee applies. Small rooms cost more per square foot because the design, permit, roof tie-in and stucco match are fixed costs, so compare whole-scope prices, not rates.
The items that move a Studio City budget
- Foundation. Slab tie-ins on the flats; raised foundations and crawlspaces in the canyon houses; caissons on steep lots.
- Electrical. Most 1950s houses still have 100-amp panels; a room with a bath and its own HVAC usually triggers a 200-amp LADWP service.
- Plumbing. A new bath is the biggest swing; houses built before 1970 often have galvanized supply lines worth replacing at the same time.
- Matching. Mid-century rooflines, clerestories and post-and-beam details cost more to continue than a plain composition-shingle roof.
- Access. Canyon lots add crane days, hand-carry and parking plans; we price them in the fixed proposal.
Fees and timeline
LADBS plan-check and permit fees are set from the valuation and are included in our price. LAUSD school fees apply when an addition adds more than 500 sq ft of assessable space. Title 24 energy compliance is part of every set, and hillside parcels usually need a soils or geology report before plan check. The County Assessor adds the value of the new square footage to your existing assessment; the original house keeps its base. Plan on 2–4 months of design and plan check at the Van Nuys Development Services Center, then 3–6 months of construction, with a hillside lot or a second story at the long end. The Studio City permit guide and the Studio City second story guide cover both in detail.
Three typical Studio City scopes and where they land
Illustrative scopes, not quotes, to show how the tiers work.
- A 12×16 bedroom with no plumbing off the back of a flat-lot 1950s mid-century north of Ventura: footing and slab tie-in, framing, a roof that continues the existing pitch, two windows, electrical and a ductless heat pump. Bump-out tier, $75K–$145K.
- A 450 sq ft primary suite with a walk-in closet and a full bath: a new foundation, plumbing run to the existing lines, a service upgrade, tile, glass and cabinetry. Room-or-suite tier, $145K–$290K.
- A 700 sq ft upper floor with two bedrooms and a bath: structural evaluation, footings and shear walls below, a stair and a new roof. Second-story tier, $290K–$520K+, toward the top on a canyon lot.
In each case the same four items decide where the project lands inside its tier: the foundation, the plumbing, the electrical service and how hard the existing house is to match. A one-hour walkthrough settles all four.
Addition or ADU on a Studio City lot?
If the new space has to connect to the house, a primary suite, a bigger family room, a home office off the hall, it is an addition and follows the lot's floor-area and setback rules. If it should stand on its own with a kitchen and its own entrance, for family or a tenant on a lease of 30 days or more, it is an ADU, reviewed under state ADU law with smaller setbacks. In Studio City the typical ADU site is a flat R1 lot north of Ventura with a detached garage at the back, or a canyon parcel where the garage pad is the only level ground. The room addition vs. ADU guide compares the two, and our ADU page for Studio City covers the unit side.
Comparing quotes for a Studio City addition
- Same scope. Square footage, room count, bathroom fixtures and the exterior match written out line by line.
- Design and engineering. Included in the price, or a separate contract you sign first.
- Permit and inspections. Plan-check fees, permit fees, school fees and the soils report, inside or outside the number.
- Allowances. Tile, cabinets and fixtures named and priced, or left as allowances that grow later.
- Payments. A deposit within the legal cap and progress payments tied to completed stages.
- License. A license number you can check at cslb.ca.gov, in the contractor's own name.
A bid far below the others usually leaves out engineering, the permit, the service upgrade or the exterior match, and those come back as change orders.
How we price a room addition in Studio City
One fixed, written price after a free on-site visit: we check the parcel, measure the house, look at the panel, the plumbing and the foundation, and itemize the design, engineering, permits, inspections and construction. Hidden conditions are priced in writing before the crew continues, the final payment follows your walkthrough, and a California home-improvement deposit is capped at $1,000 or 10 percent of the price, whichever is less. To start, see our room addition contractor page for Studio City.
Sources (checked November 2026): Los Angeles Department of Building and Safety, plan check and permit information; ZIMAS parcel lookup (zone, floor-area limit, hillside and overlay flags for any City of Los Angeles address); Los Angeles City Planning, zoning (ZIMAS), ADU ordinance and the Baseline Mansionization and Hillside ordinances; Los Angeles County Assessor: new construction is assessed and added to the existing Proposition 13 base; Education Code §17620 and the LAUSD Impact Fee Office: school fees on residential construction; additions of 500 sq ft or less of assessable space are exempt; Business and Professions Code §7044 (owner-builder permits) and §7159 (home-improvement contracts: down payment capped at $1,000 or 10 percent, whichever is less); Right Image Builders service and neighborhood pages (2026 planning ranges, timelines, permit authorities). Cost figures are Right Image Builders' 2026 planning ranges from its service and neighborhood pages.
Read before you hire anyone.
Plain answers on costs, permits, materials and hiring, written for Los Angeles houses and kept current.
How Much Does a Whole-Home Remodel Cost in Los Angeles in 2026?
Whole-home remodel cost in Los Angeles, 2026: per-sq-ft planning ranges with and without structural work, by…
Read the guide →Decision guideWhole-Home Remodel or Tear-Down Rebuild: How to Decide in Los Angeles
Remodel the whole house or tear it down? When the structure is worth keeping, LA floor-area and hillside rules, tax…
Read the guide →Decision guideRemodel or Move? How to Decide in Los Angeles
Remodel or move in Los Angeles (2026)? Prop 13 and 19, transfer taxes and Measure ULA, what an addition or remodel…
Read the guide →AnswersHow to hire a contractor
Direct answers from the Los Angeles remodeling FAQ, kept current.
Read the answers →Frequently Asked
Questions
Plan on roughly $75K–$145K for a bump-out, $145K–$290K for a full room or primary suite and $290K–$520K+ for a second floor. Flat lots north of Ventura Boulevard land lower in each tier than the canyon parcels in Fryman and Laurel Canyon.
Slope changes the foundation and the logistics. A Fryman or Laurel Canyon lot can need a soils report, caissons or stepped footings, retaining walls and crane days for materials, and the narrow streets slow deliveries, all before the room itself is built.
At 400 sq ft it sits in the room-or-suite tier, $145K–$290K. Without plumbing, on a flat lot north of Ventura, expect the lower half; add a bathroom or put it on a sloped canyon parcel and it moves toward the top.
Often. Many 1950s houses here still run on 100-amp panels, and a new room with a bath, lighting and its own heating and cooling usually needs a 200-amp LADWP service, which we include in the fixed price when the load calculation calls for it.
Design, engineering and the LADBS review usually run two to four months, and the build three to six. Canyon parcels add the soils report and more structural work, and an upper floor takes longest on both sides of the permit.
They answer different needs. A connected room is usually the lower number per square foot when it shares the house's systems; an ADU needs its own kitchen, bath and utility connections but can be rented. On a flat lot with a rear garage, a conversion is often the least expensive way to add a separate unit.
Room Addition Contractor in Studio City
Design, permits and construction, one contract →
GuideRoom Addition Permits in Studio City
Flats, hillside rules and LADBS →
GuideSecond Story Additions in Studio City
Can your house go up? →
Service HubRoom Addition Contractor in Los Angeles
Every addition type we build →
GuideBuild Up or Build Out?
Second story vs. ground-floor addition →
GuideRoom Addition vs. ADU
Connected space or a second dwelling →
Get a Fixed Price for
Your Studio City Addition
Free on-site estimate anywhere in Studio City: we pull your parcel, look at the structure and the yard, and give you a written recommendation and a fixed price before any design work.
(818) 210-4544