Room Addition Cost in Valley Village (2026): Bungalows on Raised Foundations
Valley Village's 1930s–40s bungalows are small houses on modest lots, and many have one bath. Here is what it costs to add a room or a primary suite, and what an older house adds to the scope.
A room addition in Valley Village costs about $65K–$130K for a bump-out, $130K–$250K for a full room or primary suite and $250K–$450K+ for a second story in 2026. Design, engineering and LADBS plan check usually take 2–4 months and construction 3–6 months; the 1930s–40s bungalows often need their wiring and plumbing updated where the new room connects. Size, the raised foundation, electrical and plumbing upgrades and finishes move the number.
Right Image Builders (CSLB #1021284) is a licensed room addition contractor in Valley Village, based in Valley Glen about five minutes away.
Valley Village room addition prices at a glance
| Addition type | 2026 planning range | Typical Valley Village scope | Schedule |
|---|---|---|---|
| Bump-out | $65K–$130K | A bedroom or den off a 1930s–40s bungalow | Short end of 3–6 months of construction |
| Room or primary suite | $130K–$250K | A primary suite with a second bath | 2–4 months of design and plan check, then 3–6 months |
| Second story | $250K–$450K+ | An upper floor over a 1,100–1,400 sq ft bungalow | 3–5 months of design and plan check, then 4–6 months |
Planning ranges, not quotes: design, structural engineering, permits, construction and standard finishes are included; furniture, landscaping outside the work area and utility service charges are not.
What a Valley Village addition starts from
Along Chandler and Magnolia Boulevards, around Valley Village Park and toward the edge of Colfax Meadows, many houses are 1930s–40s bungalows and small ranches of 1,100–1,400 sq ft on 6,000–6,500 sq ft R1 lots, with a detached garage off the driveway or an alley. One bath and two or three small bedrooms is common, so the most-requested addition is a primary suite.
These houses are older than the Valley's 1950s tracts: raised foundations with cripple walls, galvanized supply lines, cast-iron drains and, in many, 60-amp panels. A new suite usually means a 200-amp LADWP service and new supply lines, and the structural engineer checks the cripple walls and anchor bolts while the floor is open. On lots under 50 feet wide the side yards narrow to 10 percent of the width, so additions usually go to the rear.
What a 12×12, 20×20 or 500 sq ft room costs in Valley Village
A 12×12 bedroom or a 10×20 den is bump-out work, $65K–$130K. A 20×20 family room or a 350–500 sq ft primary suite with a bath falls in the $130K–$250K tier; above 500 sq ft of new assessable space, LAUSD school fees apply. Small rooms carry the highest price per square foot because design, permits and the exterior match are largely fixed.
The items that move a Valley Village budget
- Raised foundation. New footings matched to the existing crawlspace, with cripple-wall bracing where needed.
- Electrical. 60-amp panels in many bungalows; a 200-amp LADWP service is standard with a new bath.
- Plumbing. Galvanized lines and cast-iron drains; crawlspace access makes re-piping easier than on a slab.
- Narrow lots. Side yards shrink on lots under 50 feet wide, pushing additions to the rear.
- Bungalow details. Window proportions, siding and trim are part of the match.
Fees and timeline
LADBS plan-check and permit fees follow the valuation and are included in our price; LAUSD school fees apply only above 500 sq ft of new assessable space; Title 24 energy compliance is part of every set; and the County Assessor adds just the value of the new square footage to your assessment. Plan on 2–4 months of design and plan check at the Van Nuys Development Services Center and 3–6 months of construction. The San Fernando Valley permit guide and the guide to second stories on Valley tract homes cover both in detail.
Three typical Valley Village scopes and where they land
Illustrative scopes, not quotes, to show how the tiers work.
- A 12×16 bedroom with no plumbing off the back of a 1930s Valley Village bungalow: footing and slab tie-in, framing, a roof that continues the existing pitch, two windows, electrical and a ductless heat pump. Bump-out tier, $65K–$130K.
- A 450 sq ft primary suite with a walk-in closet and a full bath: a new foundation, plumbing run to the existing lines, a service upgrade, tile, glass and cabinetry. Room-or-suite tier, $130K–$250K.
- A 700 sq ft upper floor with two bedrooms and a bath: structural evaluation, footings and shear walls below, a stair and a new roof. Second-story tier, $250K–$450K+.
In each case the same four items decide where the project lands inside its tier: the foundation, the plumbing, the electrical service and how hard the existing house is to match. A one-hour walkthrough settles all four.
Addition or ADU on a Valley Village lot?
If the new space has to connect to the house, a primary suite, a bigger family room, a home office off the hall, it is an addition and follows the lot's floor-area and setback rules. If it should stand on its own with a kitchen and its own entrance, for family or a tenant on a lease of 30 days or more, it is an ADU, reviewed under state ADU law with smaller setbacks. In Valley Village the typical ADU site is a 6,000–6,500 sq ft bungalow lot where a JADU or a garage conversion fits better than a large detached unit. The room addition vs. ADU guide compares the two, and our ADU page for Valley Village covers the unit side.
Comparing quotes for a Valley Village addition
- Same scope. Square footage, room count, bathroom fixtures and the exterior match written out line by line.
- Design and engineering. Included in the price, or a separate contract you sign first.
- Permit and inspections. Plan-check fees, permit fees, school fees and the soils report, inside or outside the number.
- Allowances. Tile, cabinets and fixtures named and priced, or left as allowances that grow later.
- Payments. A deposit within the legal cap and progress payments tied to completed stages.
- License. A license number you can check at cslb.ca.gov, in the contractor's own name.
A bid far below the others usually leaves out engineering, the permit, the service upgrade or the exterior match, and those come back as change orders.
Ways to keep a Valley Village addition on budget
- Keep wet rooms near existing lines. A bath placed close to the current drains and supply avoids long trenches or crawlspace runs.
- Match the roof simply. Extending the existing pitch costs less than a new roof form that needs its own framing and flashing.
- Choose finishes before the price. Named tile, fixtures and cabinets keep allowances from growing during construction.
- Decide the service size early. Planning a 200-amp upgrade from the start is cheaper than adding it after the walls close.
- Avoid mid-job changes. Moving a wall after framing costs far more than moving it on paper.
None of these lowers the quality of the room; they keep the money in the parts of the addition you will see and use.
How we price a room addition in Valley Village
One fixed, written price after a free on-site visit: we check the parcel, measure the house, look at the panel, the plumbing and the foundation, and itemize the design, engineering, permits, inspections and construction. Hidden conditions are priced in writing before the crew continues, the final payment follows your walkthrough, and a California home-improvement deposit is capped at $1,000 or 10 percent of the price, whichever is less. To start, see our room addition contractor page for Valley Village.
Sources (checked November 2026): Los Angeles Department of Building and Safety, plan check and permit information; ZIMAS parcel lookup (zone, floor-area limit, hillside and overlay flags for any City of Los Angeles address); Los Angeles Municipal Code §12.08, R1 One-Family Zone: front yard 20% of lot depth up to 20 ft, 5 ft side yards (10% of width, at least 3 ft, on lots under 50 ft wide), 15 ft rear yard, Residential Floor Area up to 45% of lot area outside Hillside Areas, encroachment plane from 20 ft; Los Angeles City Planning, zoning (ZIMAS), ADU ordinance and the Baseline Mansionization and Hillside ordinances; Los Angeles County Assessor: new construction is assessed and added to the existing Proposition 13 base; Education Code §17620 and the LAUSD Impact Fee Office: school fees on residential construction; additions of 500 sq ft or less of assessable space are exempt; Business and Professions Code §7044 (owner-builder permits) and §7159 (home-improvement contracts: down payment capped at $1,000 or 10 percent, whichever is less); Right Image Builders service and neighborhood pages (2026 planning ranges, timelines, permit authorities). Cost figures are Right Image Builders' 2026 planning ranges from its service and neighborhood pages.
Read before you hire anyone.
Plain answers on costs, permits, materials and hiring, written for Los Angeles houses and kept current.
How Much Does a Whole-Home Remodel Cost in Los Angeles in 2026?
Whole-home remodel cost in Los Angeles, 2026: per-sq-ft planning ranges with and without structural work, by…
Read the guide →Decision guideWhole-Home Remodel or Tear-Down Rebuild: How to Decide in Los Angeles
Remodel the whole house or tear it down? When the structure is worth keeping, LA floor-area and hillside rules, tax…
Read the guide →Decision guideRemodel or Move? How to Decide in Los Angeles
Remodel or move in Los Angeles (2026)? Prop 13 and 19, transfer taxes and Measure ULA, what an addition or remodel…
Read the guide →AnswersHow to hire a contractor
Direct answers from the Los Angeles remodeling FAQ, kept current.
Read the answers →Frequently Asked
Questions
Expect a bump-out around $65K–$130K, a full room or primary suite around $130K–$250K and a second floor from $250K to $450K or more in 2026. The age of the bungalows makes the wiring and plumbing updates a regular part of the scope.
They are 1930s–40s houses on raised foundations with cripple walls, galvanized pipes and small panels, often 60 amps. Tying a new suite into them usually means a new service, new supply lines and checking the foundation bolting.
A 350–500 sq ft suite with a bath typically falls in the $130K–$250K tier. The crawlspace makes plumbing runs easier than on a slab, which helps.
They shape it. On R1 lots under 50 feet wide each side yard is 10 percent of the width, at least 3 feet, so rear additions are the norm, sometimes with a partial second floor where the yard is short.
Usually two to four months of drawings, engineering and Van Nuys plan check, then three to six months on site for a single-story suite.
Sometimes. On the smaller lots a junior ADU inside the existing house or a garage conversion can add a separate living space for less than a full addition, though a connected suite is better when the family needs the room.
Room Addition Contractor in Valley Village
Design, permits and construction, one contract →
GuideRoom Addition Permits in the San Fernando Valley
LADBS Van Nuys, step by step →
GuideSecond Story Additions on Valley Tract Homes
Can your house go up? →
Service HubRoom Addition Contractor in Los Angeles
Every addition type we build →
GuideBuild Up or Build Out?
Second story vs. ground-floor addition →
GuideRoom Addition vs. ADU
Connected space or a second dwelling →
Get a Fixed Price for
Your Valley Village Addition
Free on-site estimate anywhere in Valley Village: we pull your parcel, look at the structure and the yard, and give you a written recommendation and a fixed price before any design work.
(818) 210-4544