Room Addition Permits in Glendale: Zoning, Design Review and the Historic Districts
Glendale runs its own building department and its own zoning code, and it reviews the design of most larger additions. Here is how the floor-area districts, the 700 sq ft design-review line and the historic districts apply to a room addition.
A Glendale room addition is permitted by the City of Glendale Building & Safety Division at the Permit Services Center, 633 E. Broadway, not LADBS. An addition under 700 sq ft that adds no story and adds no more than 200 sq ft to a street-facing facade is exempt from design review; anything larger, and every second story, is reviewed, and houses in the nine historic districts go to the Historic Preservation Commission. On R1 lots the floor-area ratio is 0.30, 0.40 or 0.45 of the first 10,000 sq ft depending on the parcel's floor-area district, and height is 25 ft plus 3 ft for a pitched roof.
Right Image Builders (CSLB #1021284), a licensed room addition contractor in Glendale, checks the parcel's district and review path before design.
Who issues the permit
Glendale is an independent city. Its Community Development Department reviews zoning and design, and the Building & Safety Division issues permits through the Permit Services Center at 633 E. Broadway, Room 101. Glendale Water & Power handles electrical service upgrades, and Glendale Unified collects school fees on additions over 500 sq ft of assessable space before the permit is issued. Los Angeles rules such as the Baseline Hillside Ordinance do not apply.
Glendale single-family zones
| Standard | R1 (older, flatter neighborhoods) | R1R and ROS (hillside) |
|---|---|---|
| Floor area (FAR) | 0.30, 0.40 or 0.45 × the first 10,000 sq ft of lot (District I, II or III), plus 0.10 above | Same districts; lots averaging 40%+ slope limited to 0.30 plus 0.10 |
| Garage | Counts, except the first 500 sq ft (700 sq ft for homes of 3,500 sq ft or more) | Same |
| Lot coverage / landscaping | 40% coverage; at least 40% landscaped | Same |
| Height | 25 ft, plus 3 ft with a roof pitch of 3:12 or steeper | 2 stories and 32 ft, plus 3 ft for a 3:12 pitch |
| Setbacks | Front 25 ft; street side 6 ft; interior and rear 6 ft | Front 15 ft; street side 15 ft; interior and rear 10 ft |
Glendale's floor-area ratio is gross floor area plus garage area, less the garage allowance, divided by lot area. Which floor-area district a parcel sits in is shown on the city's zoning map, and it makes a large difference: on a 7,000 sq ft lot, 0.30 allows 2,100 sq ft and 0.45 allows 3,150. We confirm the district for the address before any design. The interior setback in Glendale also governs the rear lot line, so there is no separate rear-yard number.
Design review: the 700 sq ft line
An addition is exempt from design review only if it adds under 700 sq ft of floor or garage area, counted cumulatively over two years, adds no story, and adds no more than 200 sq ft to a street-facing facade. Everything else is reviewed. A second story at the rear half of the house that is architecturally compatible can be approved by the Director; other projects go to the Design Review Board, which looks at massing, the neighborhood's character, natural light and privacy. For Design Review Board cases the city mails notice at least 10 days ahead to owners and occupants within 500 ft and posts a sign on the property.
Historic districts
Glendale has nine designated historic districts: Ard Eevin Highlands, Brockmont Park, Casa Verdugo, Cottage Grove, Niodrara Drive, North Cumberland Heights, Rossmoyne, Royal Boulevard and South Cumberland Heights. In them the Historic Preservation Commission reviews additions instead of the Design Review Board, and the 700 sq ft exemption does not apply to contributing houses, so even a small rear room is reviewed for its fit with the district.
Hillside lots and fire zones
The R1R and ROS zones cover the hillside neighborhoods, with deeper setbacks and the steep-slope floor-area limit. Much of the foothill and canyon area is in a Very High Fire Hazard Severity Zone under the state map updated in 2025, which brings ignition-resistant construction, and canyon lots usually need a soils report and deeper foundations.
Remodel or addition: which permits apply in Glendale?
The path depends on whether floor area is added. A kitchen or bath rebuilt inside the existing walls needs electrical, plumbing and sometimes building permits, without a zoning review of floor area. Enclosing a patio, adding a room or a second floor adds floor area, and turning a garage into living space changes how existing floor area and parking are counted, so all of them go through full plan check: zoning, structure and energy. A garage converted into a separate dwelling with its own kitchen is an ADU and follows state ADU law instead.
Fees on a Glendale addition permit
Plan-check fees are paid when the plans are submitted and permit fees when the permit is issued; both are calculated by Glendale Building & Safety from the valuation of the work, so a bigger or more complex addition costs more to permit. School fees go to Glendale Unified and apply only when the addition adds more than 500 sq ft of assessable space, under Education Code §17620; a smaller addition is exempt. A hillside lot may add a soils or geology report and its review, and some parcels need a survey. On our projects every one of these is listed inside the fixed price, so the permit stage never becomes a separate bill.
After final inspection the County Assessor values the new square footage as new construction and adds it to the existing assessed value; the original house keeps its Proposition 13 base.
Owner-builder or licensed contractor in Glendale?
A homeowner can pull an addition permit as an owner-builder under Business and Professions Code §7044, but then takes on the duties of a contractor on that job: responsibility for workers, for the sequence of inspections and for the work passing them. With a licensed contractor those duties, the plan-check corrections and the closed permit at the end are in the contract, the deposit is capped at $1,000 or 10 percent of the price, and the license can be checked at cslb.ca.gov before you sign.
Whichever route you take, keep the approved plans and the finaled permit record with the house papers. Appraisers, insurers and the next buyer will ask for them, and they are the proof that the new square footage is legal.
What to have ready for a Glendale estimate
- The address, so the parcel can be checked before the visit.
- Any existing plans, permits or a survey of the property.
- A rough idea of the room you want and where it should go.
- Notes on earlier additions or enclosed porches, especially any built without permits.
- Your timing: a move-in date or a season to avoid, so plan check and construction can be scheduled around it.
With those in hand the visit takes about an hour: we walk the house and the lot, open the electrical panel, look at the foundation and the roof framing where we can reach them, and talk through two or three ways to place the new room. The written recommendation and fixed price follow within a few business days, with the permit path for your parcel spelled out.
How we price a room addition in Glendale
One fixed, written price after a free on-site visit: we check the parcel, measure the house, look at the panel, the plumbing and the foundation, and itemize the design, engineering, permits, inspections and construction. Hidden conditions are priced in writing before the crew continues, the final payment follows your walkthrough, and a California home-improvement deposit is capped at $1,000 or 10 percent of the price, whichever is less. To start, see our room addition contractor page for Glendale.
Sources (checked November 2026): City of Glendale Community Development, Building & Safety Division, Permit Services Center, 633 E. Broadway, Room 101; Glendale Municipal Code Title 30: Chapter 30.11 residential zones ROS, R1R and R1 (Table 30.11-B, as amended by Ordinance 6052, 2026) and Chapter 30.47 design review (§§30.47.020–30.47.040); City of Glendale, Historic Preservation: designated historic districts; Glendale Unified School District, developer fees (residential additions over 500 sq ft of assessable space); California Wildland-Urban Interface Code (Title 24, Part 7), in force January 1, 2026: ignition-resistant construction for new building in Very High Fire Hazard Severity Zones; Education Code §17620 and the LAUSD Impact Fee Office: school fees on residential construction; additions of 500 sq ft or less of assessable space are exempt; Civil Code §1102.6, Real Estate Transfer Disclosure Statement: the seller answers whether room additions or alterations were made without necessary permits; Business and Professions Code §7044 (owner-builder permits) and §7159 (home-improvement contracts: down payment capped at $1,000 or 10 percent, whichever is less); Right Image Builders service and neighborhood pages (2026 planning ranges, timelines, permit authorities). Cost figures are Right Image Builders' 2026 planning ranges from its service and neighborhood pages.
Read before you hire anyone.
Plain answers on costs, permits, materials and hiring, written for Los Angeles houses and kept current.
How Much Does a Whole-Home Remodel Cost in Los Angeles in 2026?
Whole-home remodel cost in Los Angeles, 2026: per-sq-ft planning ranges with and without structural work, by…
Read the guide →Decision guideWhole-Home Remodel or Tear-Down Rebuild: How to Decide in Los Angeles
Remodel the whole house or tear it down? When the structure is worth keeping, LA floor-area and hillside rules, tax…
Read the guide →Decision guideRemodel or Move? How to Decide in Los Angeles
Remodel or move in Los Angeles (2026)? Prop 13 and 19, transfer taxes and Measure ULA, what an addition or remodel…
Read the guide →AnswersHow to hire a contractor
Direct answers from the Los Angeles remodeling FAQ, kept current.
Read the answers →Frequently Asked
Questions
The City of Glendale: Community Development reviews zoning and design, and Building & Safety issues the permit through the Permit Services Center at 633 E. Broadway. LADBS is not involved.
Only if it adds 700 sq ft or more over two years, adds a story, or adds more than 200 sq ft to a street-facing facade. Smaller additions that meet all three tests go straight to plan check, except on contributing houses in a historic district.
It depends on the parcel's floor-area district: 0.30, 0.40 or 0.45 of the first 10,000 sq ft of lot, plus 0.10 above that, with garage area counted beyond a 500 or 700 sq ft allowance.
Ard Eevin Highlands, Brockmont Park, Casa Verdugo, Cottage Grove, Niodrara Drive, North Cumberland Heights, Rossmoyne, Royal Boulevard and South Cumberland Heights. Additions there are reviewed by the Historic Preservation Commission.
A 25 ft front setback and 6 ft on the street side and the interior lines, which in Glendale include the rear. The hillside zones use 15, 15 and 10 ft.
A small exempt addition usually fits in two to four months of design and plan check; design review, historic review or a canyon lot add time before the building permit is issued.
Room Addition Contractor in Glendale
Design, permits and construction, one contract →
GuideRoom Addition Cost in Glendale (2026)
Prices by type and size →
GuideSecond Story Additions in Glendale
Design review and height →
GuideHow Your City Changes a Remodel (2026)
LADBS vs. Burbank, Glendale and Beverly Hills →
Service HubRoom Addition Contractor in Los Angeles
Every addition type we build →
GuideBuild Up or Build Out?
Second story vs. ground-floor addition →
Check What Your
Glendale Lot Allows
Free on-site estimate anywhere in Glendale: we pull your parcel, look at the structure and the yard, and give you a written recommendation and a fixed price before any design work.
(818) 210-4544