Room Addition Cost in Burbank (2026): Magnolia Park, the Rancho and the Hills
Burbank is its own city, with its own building department, its own utility and its own school district. Here is what an addition costs in Magnolia Park, the Rancho and the hillside streets, and what moves the price.
A room addition in Burbank costs about $65K–$135K for a bump-out, $135K–$270K for a full room or primary suite and $270K–$480K+ for a second story in 2026. Burbank permits it through its own Building & Safety Division, not LADBS, and Burbank Water and Power handles any service upgrade; plan on 2–4 months of design and plan check and 3–6 months of construction. Size, the raised foundations of the older houses, the electrical service and finishes move the number.
Right Image Builders (CSLB #1021284) is a licensed room addition contractor in Burbank, based in Valley Glen about 15 minutes away.
Burbank room addition prices at a glance
| Addition type | 2026 planning range | Typical Burbank scope | Schedule |
|---|---|---|---|
| Bump-out | $65K–$135K | A dining or kitchen extension, mudroom or office off a 1920s–40s bungalow | Short end of 3–6 months of construction |
| Room or primary suite | $135K–$270K | A primary suite with a bath behind a Magnolia Park Spanish house or a Rancho ranch | 2–4 months of design and plan check, then 3–6 months |
| Second story | $270K–$480K+ | An upper floor over a 1,200–1,800 sq ft house | 3–5 months of design and plan check, then 4–6 months |
Planning ranges, not quotes: design, structural engineering, permits, construction and standard finishes are included; furniture, landscaping outside the work area and utility service charges are not.
What a Burbank addition starts from
Most Burbank additions begin with a 1,200–1,800 sq ft Spanish or bungalow house from the 1920s–40s on a 6,000–7,000 sq ft lot, the pattern across Magnolia Park and the blocks between the studios and Glenoaks Boulevard. Many of those houses sit on raised foundations with a crawlspace, so a new room is framed on new footings and tied into the original floor, with the floor height matched so there is no step between old and new. In the Rancho, the R-1-H lots carry ranch houses and horse-keeping setbacks, and the hillside streets above Glenoaks add slope, soils work and harder access.
The older houses also date the systems: knob-and-tube branch circuits, galvanized supply lines and 60- to 100-amp panels. A suite with a bath and its own cooling usually needs a larger electrical service, which is applied for with Burbank Water and Power rather than LADWP, and that application runs alongside the building permit.
What a 12×12, 20×20 or 500 sq ft room costs in Burbank
A 12×12 office or a 10×16 dining extension is bump-out work, $65K–$135K. A 20×20 family room or a 400–500 sq ft primary suite with a bath sits in the $135K–$270K tier. Past 500 sq ft of new assessable space, Burbank Unified collects school fees before the permit is issued. Small rooms always cost the most per square foot, because design, permits and matching the exterior are fixed costs that do not shrink with the room.
The items that move a Burbank budget
- Foundation. Raised floors with crawlspaces in Magnolia Park mean new footings and a level tie-in; slab tie-ins on the later ranch houses cost less.
- Electrical. Knob-and-tube and 60- to 100-amp panels; a 200-amp service through Burbank Water and Power for most suites.
- Plumbing. Galvanized lines and cast-iron drains replaced where the new bath connects.
- Matching. Spanish tile roofs, smooth plaster and divided-light windows take more care to continue than a tract stucco box.
- Lot. Horse-keeping setbacks in the Rancho and slope above Glenoaks shape where the room can go.
Fees and timeline
Burbank Building & Safety charges plan-check and permit fees based on the valuation, and those are inside our price; Burbank Unified school fees apply only above 500 sq ft; Title 24 energy compliance is part of every set; and the County Assessor adds just the value of the new square footage to your assessment. Plan on 2–4 months of design and plan check at the Burbank counter on North Third Street and 3–6 months of construction, longer for hillside lots and upper floors. The Burbank permit guide explains the city's own rules, and the Burbank second story guide covers building up.
Three typical Burbank scopes and where they land
Illustrative scopes, not quotes, to show how the tiers work.
- A 12×16 bedroom with no plumbing off the back of a 1930s Magnolia Park bungalow: footing and slab tie-in, framing, a roof that continues the existing pitch, two windows, electrical and a ductless heat pump. Bump-out tier, $65K–$135K.
- A 450 sq ft primary suite with a walk-in closet and a full bath: a new foundation, plumbing run to the existing lines, a service upgrade, tile, glass and cabinetry. Room-or-suite tier, $135K–$270K.
- A 700 sq ft upper floor with two bedrooms and a bath: structural evaluation, footings and shear walls below, a stair and a new roof. Second-story tier, $270K–$480K+, toward the top on a hillside lot.
In each case the same four items decide where the project lands inside its tier: the foundation, the plumbing, the electrical service and how hard the existing house is to match. A one-hour walkthrough settles all four.
Addition or ADU on a Burbank lot?
If the new space has to connect to the house, a primary suite, a bigger family room, a home office off the hall, it is an addition and follows the lot's floor-area and setback rules. If it should stand on its own with a kitchen and its own entrance, for family or a tenant on a lease of 30 days or more, it is an ADU, reviewed under state ADU law with smaller setbacks. In Burbank the typical ADU site is a 1920s–40s Magnolia Park lot with a detached garage, or an R-1-H Rancho lot with horse-keeping setbacks to respect. The room addition vs. ADU guide compares the two, and our ADU page for Burbank covers the unit side.
Comparing quotes for a Burbank addition
- Same scope. Square footage, room count, bathroom fixtures and the exterior match written out line by line.
- Design and engineering. Included in the price, or a separate contract you sign first.
- Permit and inspections. Plan-check fees, permit fees, school fees and the soils report, inside or outside the number.
- Allowances. Tile, cabinets and fixtures named and priced, or left as allowances that grow later.
- Payments. A deposit within the legal cap and progress payments tied to completed stages.
- License. A license number you can check at cslb.ca.gov, in the contractor's own name.
A bid far below the others usually leaves out engineering, the permit, the service upgrade or the exterior match, and those come back as change orders.
Ways to keep a Burbank addition on budget
- Keep wet rooms near existing lines. A bath placed close to the current drains and supply avoids long trenches or crawlspace runs.
- Match the roof simply. Extending the existing pitch costs less than a new roof form that needs its own framing and flashing.
- Choose finishes before the price. Named tile, fixtures and cabinets keep allowances from growing during construction.
- Decide the service size early. Planning a 200-amp upgrade from the start is cheaper than adding it after the walls close.
- Avoid mid-job changes. Moving a wall after framing costs far more than moving it on paper.
None of these lowers the quality of the room; they keep the money in the parts of the addition you will see and use.
How we price a room addition in Burbank
One fixed, written price after a free on-site visit: we check the parcel, measure the house, look at the panel, the plumbing and the foundation, and itemize the design, engineering, permits, inspections and construction. Hidden conditions are priced in writing before the crew continues, the final payment follows your walkthrough, and a California home-improvement deposit is capped at $1,000 or 10 percent of the price, whichever is less. To start, see our room addition contractor page for Burbank.
Sources (checked November 2026): City of Burbank Community Development Department, Building & Safety Division, 150 N. Third Street; Los Angeles County Assessor: new construction is assessed and added to the existing Proposition 13 base; Education Code §17620 and the LAUSD Impact Fee Office: school fees on residential construction; additions of 500 sq ft or less of assessable space are exempt; Business and Professions Code §7044 (owner-builder permits) and §7159 (home-improvement contracts: down payment capped at $1,000 or 10 percent, whichever is less); Right Image Builders service and neighborhood pages (2026 planning ranges, timelines, permit authorities). Cost figures are Right Image Builders' 2026 planning ranges from its service and neighborhood pages.
Read before you hire anyone.
Plain answers on costs, permits, materials and hiring, written for Los Angeles houses and kept current.
How Much Does a Whole-Home Remodel Cost in Los Angeles in 2026?
Whole-home remodel cost in Los Angeles, 2026: per-sq-ft planning ranges with and without structural work, by…
Read the guide →Decision guideWhole-Home Remodel or Tear-Down Rebuild: How to Decide in Los Angeles
Remodel the whole house or tear it down? When the structure is worth keeping, LA floor-area and hillside rules, tax…
Read the guide →Decision guideRemodel or Move? How to Decide in Los Angeles
Remodel or move in Los Angeles (2026)? Prop 13 and 19, transfer taxes and Measure ULA, what an addition or remodel…
Read the guide →AnswersHow to hire a contractor
Direct answers from the Los Angeles remodeling FAQ, kept current.
Read the answers →Frequently Asked
Questions
A bump-out in Burbank generally lands between $65K and $135K, a full room or primary suite between $135K and $270K, and a second level from $270K to $480K or more. Raised foundations and service upgrades through Burbank Water and Power are the usual swing items.
No. Burbank is a separate city, so the plans go to the City of Burbank Building & Safety Division on North Third Street, the electrical service goes through Burbank Water and Power, and Burbank Unified collects any school fee.
Most Magnolia Park houses are 1920s–40s Spanish and bungalow homes on raised foundations, with tile roofs and plaster that take care to match, and wiring and plumbing that usually need updating where the room connects.
A 400–500 sq ft suite with a full bath usually falls between $135K and $270K. Keeping the bath near the existing plumbing and settling the electrical service early help hold it toward the lower half.
Typically two to four months for drawings, engineering and Burbank plan check, then three to six months of construction for a single-story room; hillside lots above Glenoaks and second stories take longer.
Usually, if the room respects the R-1-H horse-keeping setbacks and the space the stables and corrals need. We map those on the site plan before the room is designed.
Room Addition Contractor in Burbank
Design, permits and construction, one contract →
GuideRoom Addition Permits in Burbank
Burbank's own rules →
GuideSecond Story Additions in Burbank
Up or out? →
GuideHow Your City Changes a Remodel (2026)
LADBS vs. Burbank, Glendale and Beverly Hills →
Service HubRoom Addition Contractor in Los Angeles
Every addition type we build →
GuideRoom Addition vs. ADU
Connected space or a second dwelling →
Get a Fixed Price for
Your Burbank Addition
Free on-site estimate anywhere in Burbank: we pull your parcel, look at the structure and the yard, and give you a written recommendation and a fixed price before any design work.
(818) 210-4544